Verona VEFSGE365NSS Operations Manual download pdf (Page 11)



LIGHTING GAS BURNERS FITTED WITH FLAME FAILURE

SAFETY DEVICE (Dual Burner)

In order to light the burner, you must:

1 – Push and turn the knob in an anti-clockwise (fig. 2.4) direction up to the

position (maximum rate of inner crown); push in and hold the knob until the flame

has been lit.

The sparks produced by the lighter situated inside the relative burner will light the

flame.

In the event that the local gas supply conditions makes it difficult to light the burner

in position, try again with the knob in position.

If there is no mains electrical supply connection, bring a lighted match close to the

burner.

2 – Wait for about ten seconds after the gas burner has been lit before letting go the

knob (safety device activation delay).

3 – Adjust the gas valve to the desired position.

If the burner flame should go out for some reason, the safety valve will automatically

stop the gas flow.

To re-light the burner, return the knob to the closed position ( ), wait for at least 1

minute and then repeat the lighting procedure.

N.B. When the range is not being used, set the gas knobs to their OFF positions

and also close the gas shut-off valve placed on the main gas supply line.

CAUTION!

The range becomes very hot during operation. Keep children well out of reach.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Verona VEFSGE365NSS Operations Manual Page 11